NevPanel® MgO Boards can be cut with a quality utility knife up to 10 mm thickness. 12 mm thickness and up can be cut and shaped with hand-saw or portable horizontal saw.

Diamond tipped hard concrete cutter or hard metal threaded cutters should be used. For minimum dust development the use of sharp and fine cutters is suggested.

NevPanel® Boards are used with C /U/M/BOX profiles in accordance with UNI EN 10215 or timber profile. Sheet thickness of sheet profiles should be minimum 0.6 mm.

NevPanel® Boards have different composition details depending on the area of their use. In a standard partition wall application, NevPanel® boards are screwed to the preconstructed studs with appropriate screws. A 3mm-gap must be left between the panels. Joint paste is applied to the joint gaps. Joint tape is mounted on the paste. To smoothen the panel surface an additional thin layer of joint paste is applied on the joint tape and screwheads.

Finally all joint-pasteapplied area is smoothened with a large spactula.

Constructed partition wall system is ready for a planned final touch such as painting, hanging wallpaper, installing wall tile etc. For paint applications the use of NevPanel® N01 Primer Undercoat or equivalent is recommended.

IMPORTANT !

Make sure the boards are completely dry before installation.

All metal components of the systems exposed to high humidity must be protected by anti-rust or anti-corrosion coatings. All fixings , accessories , etc must be in accordance with DIN EN ISO 9227

During application make sure the surface is clean and dry. All paste applications shall be made at appropriate (between +5°C to +30°C) temperatures and appropriate humidity ( less than 60%) .
Application must be performed according to manufacturers` installation manuals.

The use of Vapor barrier between the studs and boards are necessary for exterior systems

For further information contact us at info@nevra.com.tr